Are MTO's the same as BOM's? Let's take a look! First off, let's define them individually and then take a look at whe...
Read More
Mechanical Drafting 101: How to break pipe (piping plan, diagram, or isometric)
Keep the red ink away from your drawings and break pipes correctly the first time! You're a Piping Designer, and it's expected ...
Read More
Oil and Gas Acronyms You Should Know
Every Piping Designer has encountered an acronym that was new to them. Next, you're looking for acronym's on the internet, and th...
Read More
Everyone needs a Pipe Span Chart!
The maximum suggested spacing between pipe supports, shown for straight runs of pipe. The spans are based on the pipe being full of w...
Read More
A super handy Nozzle Projection Chart!
Here are the suggested minimum projections for nozzles, shown in inches. The dimensions provided may need to be increased in cases w...
Read More
Cathodic Protection Basics for Piping Designers
Cathodic protection is a term we hear often as Piping Designers. However, as much as it is a simple topic, it can also be very c...
Read More
Y-Strainers: A few USEFUL notes for Piping Designers
Every piping designer has put in a y-strainer at some point, and if this is your first time, or you simply did it without kn...
Read More
Subscribe to:
Posts
(
Atom
)